Мобильный LiveInternet Дракончики из пластики

Very few supplies and tools are needed for this little project.

Nibble out the curved side of the small strip cut from the thick sheet.

Lay the egg of foil onto the thick sheet. Wrap clay around foil.

Smooth the clay into the foil and mold the extensions together.

Roll the extensions smooth, and cut off excess, leaving about 2

Thicken base of tail, push neck up higher on body, fold over clay at head area.

Form head into a pointed cone shape.

Pinch a

Looking down on top of the head.

Blunt the nose to give him a bit of a snout.

Push the bead into the side of the head. You can line the eye cavity with silver leaf if you don

Form two tiny curved worms and place them over the beads for eyelids.

Poke nostrils with the blunt needle tool and detail a mouth crease with a toothpick or sharp tool.

Position the head and neck to add personality.

Attach the spines you made earlier to the back of the dragon.

Make the legs.

On each foot, make three little indentations with the blunt needle to form four toes.

Press legs to sides of body. Add details like horns, ears, scales.

Poke holes above eyes, add horns with ears in front.

If you liked Elizabeth Kenyon

Beginning the wings.

Texture the wings.

Apply mica powders to wings.

Apply mica powders to body, leaving a clear area at the top of the body to attach wings.

Here

You can make them a lot smaller, too. Here he is with a little friend.

And yet another friend shows up.