1. To make a wobbly neck with fibreboard discs, you'll nee [800x600]d a pair of cotter pins, 2 discs and a pair of long nose pliers (or cotter pin turner tool).

[800x600]

2. Start by inserting one of the legs of one the cotter pins through the eye of the other cotter pin

[800x600]

3. Place a disc on one of the cotter pins.

[800x600]

4. With the help of the long nose pliers, grab one of the cotter pin's leg and turn it tight over the disc

[800x600]

5. Repeat for the other leg of the same cotter pin.

[800x600]

6. Run a gathering stitch around the bear's head neck

[800x600]

7. Place the set of cotter pins and disc inside the neck, making sure the straight pin is protruding out of the neck.

[800x600]

8. Pull thread and close neck opening securely with a couple of knots.

[800x600]

9. Insert straight cotter pin through the opening at the top of the body

[800x600]

10. Place disc on the pin through the back opening of the body.

[800x600]

11. Turn pins legs in the same manner as before

[800x600]

12. Make sure the neck is not too tight, if it is, then pull head apart from the body slightly and this will loosen the pins a little making the head a little wobblier.

[800x600]