Это цитата сообщения Дикая_Орхидея_1008 Оригинальное сообщение

Креативная застежка

[500x336]

[450x302]

[450x302]

I am showing you one method today the patch method, but there are several ways to create a bound button hole. To start this one you will need the garment you are putting the button hole on and a patch. (the patch should be at least 1 inch wider than the button hole size you want and 2 inches taller than you want.) Center the patch over the desired button hole location. Pin right sides together.

[450x302]

 

Next Mark your button hole by marking both sides of the button hole. (add a little room on either side)

[450x302]

Then you will draw a rectangle 1/8 inch up from the button hole line and 1/8 inch down from the button hole line. The sides are the sides of the button hole.

[450x302]

Then sew around the edge of the rectangle.

[450x302]

Then you will cut a slit along the center line. You will want to cut in at an angle in the corners. (this will create little triangles at either end.

[450x302]

Then push the fabric through to the back.

 Press the button hole so it is flat.

[450x302]

 

Next you will create small pleats so the fold of the pleat meets in the middle of the hole.

[450x302]
Then with the right side up fold the side of the fabric up to expose the side of the backing. Sew a straight line along the edge. Be sure you are sewing

the little triangle down

. [450x302] 

Next fold up the bottom and sew along the edge. Be sure to sew the little flap down. Repeat with the other side and top doing the same thing.

[450x302]

Then if you turn around to the back you should have a nice little rectangle. Trim away the extra fabric. (this is where you could glue the edges so they won't fray using 

[400x269]