Using sandpaper or steel wool, wipe off the paint on the outside banks. Do not torture, rubbing the bank to shine - this will eventually surface will be hidden.
Although skipping this action, you will be hard to see what you do in the next steps.
It is much easier to clean when the bank has full and unopened, as the fluid inside the wall supports in the processing of abrasive, because you put pressure on them.
Step 2. Cut the lid jars
1. Pour the contents of the cans and take sharp scissors. Cut off the top, then cut the bank itself and cut off the bottom.
2. In the end must remain a rectangular sheet of thin metal. Edges can get awfully sharp and jagged! Be very careful!
3. Cut these ragged edges, but try not to cut too much material.
Step 3. Attach the plate to the elastic cardboard
Attach the plate to a flat surface that in the future you will still help. This may be a sheet of cardboard, but I used the cork from the dinner table.
Step 4. Draw a grid-box scheme
1. With a sturdy ballpoint pen and ruler, draw (engrave) line on the metal. Start with 5 cm in the middle, then around 10cm and 12cm around the same way around.
The above dimensions are suitable for cans 440 ml. If you have a bank of smaller volume, you will need to adjust the dimensions in the gauge of your material.
Step 5. Draw the picture on the top and sides
Again with a ballpoint pen put the picture on the top and sides of the box - you can draw at once, returning to the flight of his imagination, bringing fancy curls and leaves, or invent something geometric, using a ruler or template.
You can even engrave the inscription, but as you paint the inside, keep in mind that writing should be in the opposite direction.
Step 6. Sharpens the resulting pattern
1. Remove the mounting plate - now it carved pattern. He is in itself looks amazing.
2. Turn over the plate - you'll be working on the side where the image is convex. Circle all convex lines on both sides of handle. This process can be very tedious and time consuming, but in the end you will not regret it, so keep working ...
Step 7. Refreshes the original image
Again, flip the disc upside down, where you drew the first time.
The same pen spend on the same lines.
This process of drawing, stroking his back and drawing the first case the relief pattern on the box more acute.
Step 8. Cut away the unnecessary material
Step 9. Draw a line for a corner
Turn over the plate, you will work on the side where the image is convex. Ballpoint pen, draw in the corner squares of diagonal lines running radially from the center.
Step 10. Bend the lines so as to obtain a box
Bend the plate form a box.
The plate should be easy to bend in the right direction drawn by lines.
Diagonally at the corners are bent inward, then everything else bends outward. The angle between the sides is 90 degrees. Triangles within the corners can be mutually pressed to the sides.
Step 11. Bend the brink
Fold the small faces in each hand, starting with those parties, on the contrary which are pressed curved triangles.
Thus, the two functions - a bent face protects and holds the hand so that the box has not collapsed, and just cleaned raw sharp edges. Do this for all four sides and a box is finished
Step 12. Make more boxes
If you make another box with a similar design, but at 5 cm less than the previous, then the first can be used as cover.
good idea to draw a box inside a cloth or wool, or treated with glue.