Это цитата сообщения Нашалим Оригинальное сообщение

Шаль "No Lo Sé"

 

Size

Finished Size: 60” [150 cm] along top edge, 17” [42 cm] at highest point.

Yarn

Apple Tree Knits Luxe fingering (51% Silk, 49% Merino, 500 yards [457 meters] / 113 grams): Lillith Fair, 2 skeins (750-1000 yards, [685.8 to 914 meters]/ 169 to 226 grams)

Needles

Size US 2.5 [3.0 mm]: 40” (100 cm) circular

Notions

1 marker; tapestry needle; scissors; 80 6/0 beads (optional) to emphasize the tips and for the border; crochet hook for placing beads (0.5 – 1.0 mm, depending on bead size)

Gauge

21 sts and 42 rows = 4” [10 cm] in St st after wet blocking.

Abbreviations

 

dyo: double yo (yo, yo)

kff: k1, insert left ndl into old st from back to front, k left leg of this st again.

mock cable: pass the 3rd stitch on left ndl over the first 2 sts, k2 (1 st dec).

place bead: insert bead on crochet hook, pull st on left ndl through bead, replace st on left ndl.

Charts

Main Body Chart

 

For people newer to chart knitting, we’ve included the written instructions for the setup rows.

Garter Section Chart

This chart is worked with the Main Body Chart above

 

Border Chart

Pattern Notes

• The body is worked in two panels at the same time, one lace and one garter. Garter instructions are charted and included in the written directions; written directions for the lace section are included only for the first 13 rows. After that, please follow the chart.
• When working the decreases at the start of the rows make sure you end with 2 purl sts.
• If you wish to place beads on the tips do so as follows:

Beginning of Row 13 (RS): P1, sl st back to left ndl, place bead, p1, pull tight, catching up the bead.

Shawl Instructions

CO 7 sts

Row 1 (WS): P5, pm, kfb, k1 (8 sts).

Row 2 (RS): P3, sm, k2, yo, k3 (9 sts).

Row 3 (WS): P4, k1, p1, sm, kfb, k2 (10 sts).

Body

Body Setup Row 1 (RS): Begin working Row 1 of Main Body Chart over 4 sts, sm, ssk, k1, dyo, k3 (12 sts).

Body Setup Row 2 (WS): P4, k2, p1, sm, work Main Body Chart to end (13 sts).

Body Setup Row 3: Work Main Body Chart, sm, (ssk, k to last 3 sts, dyo, k3) (16 sts).

Body Setup Row 4: (P4, k to last st before marker, p1), sm, work Main Body Chart to end (17 sts).

Rep Body Setup Rows 3-4 four more times, working through Row 12 of Main Body Chart.

Row 13 (BO at the beginning of Row 13): Place bead (optional), p1, p1, place sts back on left ndl, p2tog, pass the 3rd stitch on left ndl over the first 2 sts, BO 2 sts, BO 3 sts purlwise, sl rem st from right ndl to left, purl it and complete Row 13.

Continue to work reps of Rows 13-24 from the chart until you have a total of 23 tips, or until you have used as much as 75% of your yarn. Work Rows 13-21 once more.

Border

Continuing to work the garter section as above, work Rows 22-38 of Border Lace 1 time from chart, then continue to work reps of Rows 31-38 as desired, ending the final rep on Row 36.

The sample was worked with 1 rep of Rows 31-38, then 1 section of Rows 31-36.

When done with the border, bind off with one of the options below:

Non-beaded BO: K1, *k1, pass both stitches back to left ndl, k2tog tbl, rep from* until 1 st rem, cut yarn and pull end through last loop.

Beaded BO: *K1, sl st back to left ndl, place bead, k1, pulling tight; (k1, pass both sts on right ndl back to left ndl, k2tog tbl) until you reach the center stitch that lines up above the sk2psso in Row 35, rep from * until all sts have been worked, placing the last bead on the last st; cut yarn pull end through last loop.

Finishing

Weave in ends and block.

Written direction for Lace panel Rows 1-13

Row 1 (RS): P2, kff, p1 (4 sts).

Row 2 (WS): Kfb, p2, k2 (6 sts).

Row 3: P2, k1, yo, k1, pfb, p1 (8 sts).

Row 4: Kfb, k2, p3, k2 (9 sts).

Row 5: P2, k3, p2, pfb, p1 (10 sts).

Row 6: Kfb, k4, p3, k2 (11 sts).

Row 7: P2, mock cable, p4, kff, p1 (11 sts).

Row 8: Kfb, p2, k4, p2, k2 (12 sts).

Row 9: P2, k1, yo, k1, p4, k1, yo, k1, pfb, p1 (15 sts).

Row 10: Kfb, k2, p3, k4, p3, k2 (16 sts).

Row 11: P2, k3, p4, k3, p2, pfb, p1 (17 sts).

Row 12: Kfb, (k4, p3) 2 times, k2 (18 sts).

Row 13: Place bead (optional), p1, p1, place sts back on left ndl, p2tog, pass the 3rd stitch on left ndl over the first 2 sts, BO 2 sts, BO 3 sts purlwise, sl rem st from right ndl to left (shown as an “L” in the chart), purl it, p1, mock cable, p4, kff, p1 (11 sts).

 

        https://knotions.com/issues/april-2018/pattern-april-2018/no-lo-se-shawl/